A Supervisor's Walk-Through of Pushing, Pulling and Carrying in an Irish Workplace
A supervisor who only checks whether people “bend their knees” on a lift will miss a large part of the handling risk in an Irish workplace. The jobs that cause trouble are often the ones that look ordinary: a cage pushed onto a shop floor, a bin pulled out of a yard, a tray carried up a stairs because the lift is busy.
This article is a short walk-through you can use on your own floor. It is not legal advice. HSA guidance remains the official reference. For structured training that includes these tasks, start at Irish Manual Handling.
Walk the route, not only the storeroom
Follow one regular pushing or carrying job from start to finish. Where does the load begin? Where does it go? Where do people pause, twist, or take a short cut? A corridor with a damaged threshold or a drain cover can turn a manageable trolley into a shoulder injury. A “short carry” that is repeated forty times a day is not short in any useful sense.
Watch the start, the turn, and the stop
Starting a heavy trolley, turning it in a tight aisle, and stopping it before a door are often harder than moving it in a straight line on a good floor. Look at handle height, wheel condition, and whether the load is stacked so high that the person cannot see. Look at whether people pull when they should push, or vice versa, because the layout gives them no choice.
Talk through TILE with the person doing the job
Ask what feels awkward. Ask whether they have a previous injury that this handle or this carry aggravates. Ask whether the aid they are meant to use is actually available. This is the assessment happening in real time, and it is more useful than a generic poster about lifting.
Agree one change, then back it
The change might be a smaller load, a repaired wheel, a different route, a second person for a slope, or a rule that a particular carry is no longer done on the stairs. Write it down in the assessment or in a simple briefing note. Then make sure the next shift is told, because a method that only one person follows will not last.
Training supports this walk-through; it does not replace it. A course from Irish Manual Handling can give people a shared language for TILE and for when not to force a job. After the course, repeat the walk-through on a real trolley or a real carry, so the briefing and the work match.
If you do this once a month, or after any near miss involving a trolley or a carried load, you will catch problems that a lift-only assessment will never see. Official HSA guidance should sit behind the method. For the training part, open Irish Manual Handling and then take the lessons onto the floor, along the routes your team already uses every day.
What to do with a near miss involving a trolley or a carried load
A cage that almost tips, a bin that jars on a drain, or a person who stops mid-carry because a shoulder has gone tight, is information. It should go back into the walk-through and into the assessment, not only into a comment in the corridor.
On the same day if you can, look at the aid, the route and the load. Was the wheel already damaged? Was the cage overloaded? Was the carry being done on stairs because a lift was busy? Fix what you can immediately, and tell the next shift, because the same job will otherwise be repeated in the afternoon.
If a person has been hurt or has a previous injury that this job aggravates, treat that as part of TILE, not as a reason to change the subject. Adjust the job, and do not ask them to “try it again” in the same conditions.
A short note in the assessment, and a short briefing, will do more than a promise to “be careful with the cages”. Training can support the standard you want; official HSA guidance should inform the method. The walk-through described in this article is not only a quiet-day habit. It is also the right response when a trolley or a carried load has already tried to teach you something.