Inspecting Ladders and Platforms before a Height Job in Ireland

The most effective height control, after avoidance, is often a decision not to use damaged or incomplete equipment. That decision only happens if someone looks, knows what they are looking for, and feels able to take the kit out of service. Inspection is therefore part of training, not an extra chore for a quiet day.

This article is a practical briefing for Irish workplaces that use ladders, stepladders, towers or other platforms. It is not a substitute for the manufacturer’s instructions or for official HSA guidance. For a structured online briefing, review the current course at Irish Working at Heights.

Before a ladder is used

Look at the stiles, the rungs, the feet and any locking devices. Look for cracks, dents, wear, missing parts, and paint or repairs that may hide damage. Check that the ladder is long enough for the job, that it can be placed on a firm, level base, and that it will not be used as a platform for work it cannot support. If the ladder fails any of those points, it is not used.

Formal inspections should be recorded, and a failed ladder should be marked or removed so that a colleague does not take it out again.

Before a platform is used

Towers should be erected by people who know the manufacturer’s method, on suitable ground, with the right components, guardrails and access. Mobile elevating work platforms need trained operators and a look at ground conditions, overhead obstructions and rescue. Gates and mid-rails on mezzanines should actually be in place. A platform with a missing piece is not “nearly fine”. It is incomplete.

Inspection does not replace the first questions

A perfect ladder is still the wrong equipment if the job should have been done from the ground, or if a working platform is reasonably practicable. Inspection sits after those questions, not instead of them. Training should keep that order clear, or people will polish a poor method.

Who should be taught to look

Anyone who selects, inspects or uses the equipment needs the habit, and so do the people who authorise the job. New starters and contractors should not be left to copy whoever seems confident. Irish Working at Heights provides an online Working at Heights course with video training, an assessment with unlimited retakes and an instant certificate. Confirm the current outline on the live page. Then show people the equipment you actually hold, including anything that should already have been withdrawn, so that the inspection habit is specific rather than abstract.

After a failed check

The job waits. A workaround with a damaged stile, a missing foot or an incomplete tower is not a plan. Supervisors should back that pause in front of colleagues. Keep records of inspections and of training, and review both when new kit arrives.

Formal inspections and the everyday look work together

A recorded inspection at set intervals is not a reason to skip the look before use. Equipment can be damaged on the job after it was last signed off. The everyday check is how that damage is caught. The formal record is how you show that inspections happen, and how you take a pattern of faults seriously.

If the same ladder or platform fails repeatedly, ask whether it should be replaced rather than repeatedly repaired, and whether the way it is stored or transported is part of the problem. A kit that is thrown onto a van floor will not stay in good condition, however carefully it is inspected later.

Share failed inspections with the people who use the equipment, so that the lesson is visible. A tag or a clearly marked quarantine area is more reliable than a verbal warning that a colleague may not hear.

For official and technical detail, use the current regulations and HSA guidance. For a consistent briefing on planning, equipment and the limits of ladders, start at Irish Working at Heights and then put a pre-use look at the centre of the job. An inspection that can stop the work is worth more than one that is only a tick on a form.

Irish Working at Heights